Chapter 2 - Features set
User Manual
R5000 series - Web GUI
37
Figure 36 - Google Map
Type the location name in the Address bar, press the «Find» button to search for it
and then move to the exact location where the unit is installed. Double click in that
position on the map and the Google pointer (see picture above) will be placed there.
After pressing the «Ok» button,
“Latitude” and “Longitude” fields are automatically
filled in with the GPS coordinates.
2.4.2. Network Settings
In the Network Settings section, there are displayed all physical and logical network
interfaces that are already configured. The physical interfaces (eth0 and rf5.0) are
set by default and they cannot be removed. For these two interfaces, you are allowed
to change the parameters only.
For the following layer 2 and 3 logical interfaces, you are allowed to add (by pressing
the corresponding buttons and specifying the interface number), remove and change
the parameters of the interface:
-
Pseudo Radio Interface - prfX
can be attached to the Ethernet interface in
order to allow it to work as a radio interface using the MINT protocol, so that the
node can find its neighbors and establish the links with them through this
interface. The interface encapsulates MINT-frames into the Ethernet-frames
and allows connecting the units of the MINT network using wired interfaces.
Also, this interface can be joined with other interfaces;
-
VLAN - vlanX
can be assigned to a physical interface or to a virtual interface
sviX. It is used for the creation of the logical network topology regardless of the
physical topology of this network. VLAN allows creating groups of interfaces
