2.3
Configuration
The demoboard can be easily configured via jumpers on the board.
The board provides the following configuration options:
•
connect the enable signal EN to VIN or to GND with a jumper
•
connect the RADJ pin to GND with a jumper to select the default reset thresholds
2.3.1
EN selection
The EN pin can be connected to either GND or to VIN by placing a jumper as shown in
always connected to the external banana-plug. If the jumper is placed, then do not connect an external signal
to EN.
Figure 3
EN jumper (left: EN to VIN; right: EN to GND)
OPTIREG
™
linear voltage regulator TLS820F3ELVxx demoboard
Z8F68163446
2 Demoboard
User manual
7
Rev. 1.0
2020-02-26
