Application Kit TC2X4
Hardware Manual
Application Kit Information
User’s Manual
3-5
V 1.0, 2014-10
3.7
USB Connector
The USB connector is used for connection to a PC. Via the USB it is possible to power
the board, using the ASCLIN0 as serial connection via USB and Debugging via DAS. For
the pinout of USB socket see
.
NOTE: Before connecting the board to the PC, make sure that the actual DAS software
is installed on the PC. For actual DAS software please contact your local FAE.
The software can also be found on the
3.7.1
Serial Connection to PC
After the first connection of USB to a PC the needed driver will be installed automatically.
During this there will be created a new COM port on PC. This COM port can be used to
communicate with the board via ASC0 of the device (e.g. bootstrap loader).
3.7.2
miniWiggler JDS
The miniWiggler JDS is a low cost debug tool which allows you access to the JTAG of
the device. Make sure that you have the latest DAS release. Debugging is possible via
the DAS Server ‘UDAS‘. Please contact your prefered debug vendor for support of DAS.
If you have connected the board to the PC and there runs the DAS server, then a working
connection is visible via the green ACTIV LED.
The status RUN LED is switched on/off through the DAS Server, depending on the used
debugger (client).
IMPORTANT: Make sure that there is no or a tristated connection on X301 (OCDS1) if
the ACTIV LED is on.
3.8
Beeper
The board has an electro-acoustic transducer which can be used for an acoustic output.
The transducer is connected to pin P33.0 and needs a 2048Hz frequency.
3.9
MultiCAN
On the board is oneCAN transceiver connected to the MultiCAN on TC2X4 node 0. The
transceiver is connected to an IDC10 plug. For the pinout of IDC10 plug see
.
You can use a IDC female connector with crimpconnector, flat cable and SUB-D 9 plug
with crimpconnector to have a 1:1 adapter to SUB-D 9.
Downloaded by [email protected] 09/08/2019 14:04:27
