Date: 03/2021
All rights reserved. © 2021 Infineon Technologies AG
Before you start
›
Ensure that you have the following:
• PC with USB port
• UART terminal software such as Tera Term
or Minicom
›
required software.
›
Ensure the jumper J12 is at position 2-3 to select 3.3 V.
›
Connect the KitProg3 USB connector (J10) to your PC.
›
Wait for the driver installation to complete.
Step 1: Connect the kit with UART terminal software
›
Open the UART terminal software and connect to
the kit’s USB-UART COM port with the following settings:
• Baud rate: 115200 bps
• Data: 8 bit
• Parity: None
• Stop bit: 1 bit
• Flow control: None
›
Press the XRES switch (SW1) to reset the device.
Step 2: Run the pre-programmed code example
›
Follow the instructions displayed on the UART
terminal to use the pre-programmed
code example.
Step 3: Observe the user LED (D13) brightness variation
›
Observe the state of the user LED (D13) with the variation
of ambient light intensity. The LED turns ON when the
ambient light intensity is lower than 45% and turns OFF
when higher than 55%.
Quick start guide
PSoC 62S4 pioneer board
USB-UART COM port setup
Instructions displayed on the UART terminal
Observe the brightness in LED (D13)
Document Number: 002-30749 Rev. *C
