Application Note
8
<Revision 2.4>
<<2019-06-17>>
Assembly Instructions for the Easy-PressFIT Modules
Figure 8
Easy2B with TIM
The structure of the presented TIM surface is only exemplary and not fixed for all products within the Easy
family.
The stamp should not touch the TIM material during press-in. That is why the stamp only touches the substrate
areas without TIM. Figure 9 shows the geometries of the stamp for the press-in of Easy1B and Easy2B modules
with TIM.
Figure 9
Press-in stamp of Easy1B (left) and Easy2B (right)