Infineon iMOTION EVAL-IMM101T Series, User Manual

Page: 8 / 39

8 of 38
EVAL-IMM101T
Smart IPM evaluation board application note
Pin assignments
4 Pin assignments
Table 4 Pinout description for IMM101T – single motor control use case – typical configuration
Pin Name Type Description
1 Vbus scaled I Vbus scaled ADC input
2 CREF I/O Analog Overcurrent Comparator threshold DAC
3 V
DD
P Digital V
DD
input [3.3V – 5.0V]
4 P1.7 I/O Digital Input --- Analog and Digital Output
5 Vcc P 15V gate driver power supply input
6 V
SS
1 P Gate Driver Power ground, connect externally via PCB to pin 36
7 VbV P V phase bootstrap capacitor positive
8 VbW P W phase bootstrap capacitor positive
9,10 VsU P U phase output
11,12 VrU P Leg U return – Low-Side MOS source
13,14 VrV P Leg V return – Low-Side MOS source
15,16, 40 VsV P V phase output and V phase bootstrap capacitor negative
17,18,19 VsW P W phase output and W phase bootstrap capacitor negative
20,21 VrW P Leg W return – Low-Side MOS source
22~29 Vbus P DC bus voltage
30, 39 VsU P U phase bootstrap capacitor negative
31 VbU P U phase bootstrap capacitor positive
32 RX0 I Serial Port Receive input
33 TX0 O Serial Port transmit output
34 Vsp I Analog Voltage Set Point Input
35 IW (or H0) I Analog Current sense input phase W or Hall0 input
36,41 V
SS
2 P Signal ground --- Connect externally via PCB to pin 6
37 IV (or H1) I Analog Current sense input phase V or Hall1 input
38 ISS or IU I Analog Current sense input phase U or single Shunt
29
28
21 20
1
Top View
27
39
40
41
23 22 25 24 26
2 3 4 5 6 7 8 9 10
12
13
16
15
17
18
19
30
31
32
33
34
35
36
37
38
Note
Pins 39 and 40 are not required
to be connected electrically on
the PCB but are recommended
to be soldered for mechanical
stability.
14
11
Figure 4 IMM101T series pinout