Application Note
9
<Revision 1.2>
<2017-11-09>
Manual for HybridKIT Evaluation Gate Board
HybridKIT Evaluation Gate Driver Board for 750V EDT2 IGBT
Quickstart Guide
4.3
Supply of the Gate Driver Board
The gate driver board requires a low voltage supply between 8V..18V for the operation. For longer testing times
a voltage at about 14V is preferred.
Figure 5 The gate driver board can be supplied from the signal connector e.g. via the interface PCB
(reverse polarity protected) or alternative directly on the PCB testpads. Please respect the right supply
polarity when using the testpads!
The green LEDs (marked with 12V and 5V on the PCB top located of the connector) indicate right power supply
of the gate driver board.
