CY8CKIT-064S0S2-4343W PSoC 64 Standard Secure – AWS Wi-Fi BT Pioneer Kit Guide, Doc. # 002-30680 Rev. *B
7
1.
Introduction
Thank you for your interest in the CY8CKIT-064S0S2-4343W PSoC 64 Standard Secure – AWS
Wi-Fi BT Pioneer Kit. The PSoC 64 Standard Secure – AWS Wi-Fi BT Pioneer Kit enables you to
evaluate and develop your applications using the
PSoC 64 Standard Secure - AWS MCU
(hereafter
called “PSoC 64 MCU”) and CYW4343W WICED Wi-Fi/BT combo device.
PSoC 64 MCU is Cypress’ latest, ultra-low-power PSoC specifically designed for Secure IoT
products. PSoC 64 MCU is a true programmable embedded system-on-chip, integrating a 150-MHz
Arm
®
Cortex
®
-M4 as the primary application, up to 1856 KB Flash and 920 KB SRAM, Secure
Digital Host Controller (SDHC) supporting SD/SDIO/eMMC interfaces, CapSense
®
touch-sensing,
and programmable analog and digital peripherals that allow higher flexibility, in-field tuning of the
design, and faster time-to-market. In addition, it delivers a pre-configured, PSA level-2 compliant
secure execution environment, which is custom-built to support the Amazon FreeRTOS ecosystem.
PSoC 64 MCU also includes a rich execution environment for application development, with Amazon
FreeRTOS support that communicates with the secure execution environment.
The PSoC 64 Standard Secure – AWS Wi-Fi BT Pioneer Board offers compatibility with Arduino™
shields. The board features a PSoC 64 MCU, and a CYW4343W Wi-Fi/Bluetooth combo module.
Cypress CYW4343W is a highly integrated single-chip solution that includes a 2.4 GHz WLAN IEEE
802.11 b/g/n MAC/baseband/radio and Bluetooth 5.1 support. The WLAN section supports SDIO
interface to the host MCU (PSoC 64 MCU), and the Bluetooth section supports high-speed 4-wire
UART interface to the host MCU. In addition, the board features an onboard programmer/debugger
(KitProg3), a 512-Mbit Quad SPI NOR flash, a 4-Mbit Quad SPI F-RAM, a micro-B connector for
USB device interface, a 5-segment CapSense slider, two CapSense buttons, a microSD card holder,
an RGB LED, two user LEDs, one potentiometer, and two push buttons. The board supports
operating voltages of 1.8 V, 2.5 V and 3.3 V for PSoC 64 MCU.
You can use ModusToolbox
®
to develop and debug your PSoC 64 MCU projects.
is a set of tools that enable you to integrate Cypress devices into your existing development
methodology.
If you are new to PSoC 64 MCU and ModusToolbox IDE, refer to the application note
Getting Started with PSoC 6 MCU on ModusToolbox
to help you familiarize with the PSoC 64 MCU
and help you create your own design using the ModusToolbox IDE.