Infineon BTT3018EJ, User Manual, Page: 6 / 14

User Manual 6 <Revision 1.0>
2017-11-
22
Demoboard BTT3018EJ User Manual
Demoboard configuration panel
o
To use the Vout measure, user needs to go to “demoboard configuration panel” to set the
monitoring resistors. It is a simple voltage divider that should be designed to protect the Arduino
microprocessor in current and voltage. Resistors can be connected in the “Tulip” connectors
without soldering. Examples of values:

Rmonitor1 = 10k Ω

Rmonitor2 = 1k Ω
o
Vstatus can be in the pull up mode or can be connected to Vin, user needs to go to “demoboard
configuration panel” to set the right statement.
Set the monitoring resistor
then apply to make Vout
enabled
Click on ON/OFF to change
the status configuration
(Red: pulled-up to Vdd)
Turn ON/OFF
Continuous mode
The pulse mode
The PWM mode