Infineon AURIX lite Kit V2, User Manual, Page: 17 / 27

AURIX
™ lite Kit V2
Hardware Description
Board Users Manual 17 Revision October, 2020
4.2 Shield2Go and MikroBus
™ Pinout
The pin connectors for the Shield2Go Connectors 1 and 2 and the mikroBus
™ can be used to extend the
evaluation board or to perform measurements on the AURIX
™ TC3X5/TC2X5. Figure 6 shows the available
signals at these connectors. The pin table is also printed onto the top and bottom side of the AURIX
™ lite Kit V2.
Shield2Go Connector 1 Shield2Go Connector 2
AURIX
™Pins AURIX™
Pins
AURIX™
Pins AURIX
™ Pins
1 +5V 5V
1
+5V 5V
2 AN16 AN1 RX P33.8 10
2
AN18 AN1 RX P20.3 10
3 AN17 AN2 TX P33.9 11 3 AN19 AN2 TX P20.0 11
4 P13.2 2) SDA RST/GPIO2 P23.4 1) 12 4 P13.2 2) SDA RST/GPIO2 P23.5 1) 12
5 P13.1
2)
SCL GPIO1 P32.2 13 5 P13.1
2)
SCL GPIO1 P32.3 13
6 GND GND CS P20.13 1) 14 6 GND GND CS P20.10 1) 14
7 +3V3 3V3 SCLK P20.11 1) 15 7 +3V3 3V3 SLCK P20.11 1) 15
8 P00.4 INT/GPIO3 MOSI P20.14
1)
16 8 P10.8 INT/GPIO3 MOSI P20.14
1)
16
9 P14.9
1)
PWM/GPIO4 MISO P20.12
1)
17
9
P14.10
1)
PWM/GPIO4 MISO P20.12
1)
17
mikroBus™ Connector
1
AN26 AN PWM P2.8 16
2
P10.6 RST INT P10.7 15
3
P14.7
1)
CS RX P15.1 14
4
P15.8
1)
SCK TX P15.0 13
5
P15.7 1) MISO SCL P13.1 2)
12
6
P15.6 1) MOSI SDA P13.2 2)
11
7
+3V3 3.3V 5V +5V 10
8
GND GND GND GND
9
Figure 6 Signal mapping of the pin headers for Mikrobus and Shield2Go Connector 1 and 2
Note:
1)
Different signal compared with AURIX™ TC275 lite Kit V1.x
2)
The I2C buses SCL and SDA are shared on the Shield2GOs, mikroBus™, Arduino connectors and the I2C eeprom.