Infineon AURIX lite Kit V2, User Manual, Page: 15 / 27

AURIX
™ lite Kit V2
Hardware Description
Board Users Manual 15 Revision October, 2020
3.3 Optional resistors
Some resistors/bridges enable/disable or changing functions of specific signals in Table 8.
To disable the signals, the resistors have to be removed. To enable, the resistor has to be assembled.
For example : Desoldering the intialy assembled resistor R33, disables the Potentiometer and the analog Signal
AN0 of the
AURIX™, making it usable for other purposes.
Table 8 Signal mapping of the optional resistors
Resistor Res. Assembled Signal Size
(imperial) Comment
R33 0
Ω
yes AN0 0603 Disassemble to disable the potentiometer
R37 0
Ω
yes XTAL2 0603
Serial resistor to reduce oscillator
amplitude if needed.
R39 0
Ω
no +5V 0603 Assemble to connect 5V to Mikrobus and
Shield2Go connector
R59 4.7 k
Ω no
HWCFG6/P14.4 0603 Assemble to disable the internal pull-ups
with power on
R52 4.7 k
Ω No
HWCFG2/P14.2 0603 Assemble to enable the EVR13, only
needed with TC2X5 and R59 assembled
R53 4.7 k
Ω no
HWCFG3/P14.3 0603 Assemble to boot from BMI, only needed
with TC2X5 and R59 assembled
R56 4.7 k
Ω no
HWCFG3/P14.3 0603 Assemble to select boot from
HWCFG4/5, valid setting on P10.5/P10.6
needed
R54 4.7 k
Ω no
HWCFG4/P10.5 0603 Set HWCFG4 to high, only needed with
R56 assembled, not with R57
R55 4.7 k
Ω no
HWCFG5/P10.6 0603 Set HWCFG5 to high, only needed with
R56 assembled, not with R58
R57 4.7 k
Ω no
HWCFG4/P10.5 0603 Set HWCFG4 to low, only needed with
R56 assembled, not with R54
R58 4.7 k
Ω no
HWCFG5/P10.6 0603 Set HWCFG5 to low, only needed with
R56 assembled, not with R55
R44 0
Ω
no P14.1, P00.12 0603 Assemble to use ASCLIN4 (P00.12)
instead of ASCLIN0 (P14.1) via USB,
only with TC3X5, P14.1 not usable in this
case
R45 0
Ω
no P14.0, P00.9 0603 Assemble to use ASCLIN4 (P00.9)
instead of ASCLIN0 (P14.0) via USB,
only with TC3X5, P14.0 not usable in this
case