Application Note
6 of 22
002-34322 Rev. *A
2021-12-14
Getting started with AIROC™ IFW56810 Single
-band Wi-Fi 4 Cloud
Connectivity Manager
Getting started
4
Getting started
4.1
Connect the kit to the PC
Connect the IFW956810 Single-band Wi-Fi 4 Cloud Connectivity Manager evaluation kit to the PC using either
the Type-C connector or Type-A male to Type-C female cable.
Figure 4
Connect the USB dongle to the PC
4.2
Set up the host machine
Run a serial terminal to communicate with the kit over USB by choosing higher of the two enumerated COM
ports with the following configuration.
•
Baud rate:
115,200
•
Bits:
8
•
Parity:
None
•
Stop:
1
•
Flow control:
None
•
Local Echo:
Yes
•
End of Line:
Line Feed
See Section
Once you open the serial terminal, type
AT+CONF? About
in the serial terminal.
You should see a response “
OK Infineon IFW56810 CCM
”
.
Steps in sections
are required only for the first time you connect. The IFW56810 module will
remember its configuration and will be ready to connect to your AWS account automatically.
Jump to Section
if the kit has already been configured to connect to AWS.
4.3
Set up your AWS account and permissions
Follow the instructions in Amazon documentation (
) to create your account and get
started.
1.
Sign up for an AWS account.
2.
Create a user and grant permissions for access to AWS IoT resources.
3.
Open the AWS IoT Console.
