AP29002
Standalone TwinCAN Controller
Using special features of the 82C900
Application Note
9
V 1.0, 2004-02
An example using the SSC Slave mode of the 82C900 was implemented using the
82C900 evaluation board and an Infineon C167CR as the host microcontroller. The
82C900 evaluation board was connected directly to the Phytec KitCON167 evaluation
board for the C167CR.
Note:
Please note that this example can also be implemented on many other Infineon
Microcontrollers, such as the C161PI. If you want to use the Phytec C161O
KitCon board, the board needs to be connected with wires because P3.4 of the
KitCon board is used for other functions. So another port pin has to be used for
the /RDY signal. But if wires are used noise can be a problem, if the wires are to
long or the connectors are not good enough.
The jumper configurations on the 82C900 starterkit are shown in Table 1.
Table 1
Jumper settings for SSC-Slave-Mode
JP10
1-2 connected: SLS on CTRL0
JP32
Open (MODE0 = ‘1’)
JP33
Close (MODE1 = ‘0’)
JP38 All
open
JP39
3-7 closed,
1-2 depending which interrupts are used
8 open
JP40 All
open
