Inficon Pernicka 700H CHLD, Translation Of The Original Operating Instructions

Page: 44 / 100

6 | Operation INFICON
44 / 100 Pernicka-700H-CHLD-Operating-instructions-jin76aen1-04-(1911)
Message window
To display status messages in the yellow field, e.g. "Leak Test done" (measurement
process completed); the operating mode e.g. "Standby" and the time measuring
progress.
6.2.1.2 Setting the "Measure" window
► To open the "Measure” window, press the tab "Measure".
Display of the linear scaled measuring signal
during the accumulation phase
Display of the logarithmically
scaled measuring signal during
the entire measuring procedure
Cathode in
ON/OFF
Amplifier
ON/OFF
Selection
menu
Message
window
System
diagram
CHLD-Sensor
SEM -
Fig. 21: Window "Measure"
In addition to the standard settings, the "Measure" window offers additional options for
configuring the measurement process. At the same time, the current status of the
individual components of the device during the measurement are displayed in the
system diagram.
This window is suitable for appropriately trained operators and for maintenance and
service personnel as well as for measurements with a high configuration requirement.
Button Description
Abort Terminating the ongoing process.
► For example, to stop regeneration before the end of the
set end time, press this button.
Init VACsys ► To set the device in the "Standby" operating mode,
press this button.
Calibrate ► To start the calibration, press this button. See
"Calibrating [
}
58]".
Load/Unload To purge test chamber with purge gas. This function can
also be used to open the lid of the test chamber.