Inficon HLD6000, Translation Of The Original Operating Instructions

Page: 42 / 90

6 | Operation INFICON
42 / 90 HLD6000-Operating-instructions-kinb43en1-05-(2107)
As "operator" you see the symbol , as "supervisor" you see the symbol .
Starting procedure in delivery condition
A stored PIN number is assessed during the starting procedure.
The PIN "0000" is preset in delivery condition. This means the device is started with a
log-in as "supervisor".
Starting procedure after assigning the PIN
The "supervisor" can protect existing settings by inputting a PIN number. After
restarting the device it restarts with a log-in as "operator". This can be switched over
to "supervisor" only when the correct PIN is entered.
6.2.11.1 Protecting settings via PIN assign
ü
You are logged in as a "supervisor” .
1
> Access Ctrl. > Supervisor > PIN Assign
2
Enter a 4-digit number of your choice as the PIN.
ð
So that your settings are protected, do not select "0000", see "Access to the
settings [ } 41]", section “Starting procedure in delivery condition".
To cancel protection again, enter “0000” as the PIN (factory setting).
If you have forgotten the supervisor PIN, then please contact the INFICON service
team.
Further information can be found from the help text when entering the PIN.
6.2.11.2 Switch from supervisor to operator
ü
You are logged in as a "supervisor” .
► > Access Ctrl. > Operator
If you have stored a PIN for an operator, alternatively switch the device off and on
again.
6.2.11.3 Switch from operator to supervisor
1 > Access Ctrl. > Supervisor
2 Enter the PIN which is stored for logging in as "supervisor".
6.2.11.4 Changing parameter access controls
ü
You are logged in as a "supervisor” .
1 > Parameter > Parameter access level