6
Install Two “D” Cell Alkaline Batteries
WARNING
To prevent ignition of a hazardous atmosphere, batteries must only
be changed in an area known to be non-hazardous (i.e., free of
combustible gas).
CAUTION
Use only Duracell
®
MN1300 “D” size batteries to maintain
intrinsically safe approval.
1.
Remove the battery cover by releasing the latch and sliding the cover down and
off the handle. You may need a small flat-blade screwdriver to assist with
releasing the latch.
2.
Install two Duracell
®
MN1300 “D” size alkaline batteries as shown in
.
Figure 1 Properly installed alkaline batteries
3.
Reinstall the battery cover by aligning it in the grooves on the handle and sliding
it up the handle until it latches.
NOTE:
If the Battery indicator flashes or if the Battery and highest signal indicator
both flash, the batteries are low and should be replaced.
NOTE:
Dispose of depleted alkaline batteries according to applicable state and
local regulations. In the absence of such regulations, recycle and/or
dispose of batteries through voluntary waste recycling programs.
+
- +
-
