Inficon Ecotec E3000, Technical Handbook

Page: 86 / 146

4-28
Equipment Settings
ki
n
a
22
e c
h
ap
te
r 4
.fm
te
chn
ica
l ha
nd
boo
k
(1
20
6)
4.6.6 Select PLC Outputs
In the
SELECT PLC OUTPUTs
submenu the user can select which pin on the I/O port
(suitable for PLC output) represents which command. There are four PLC outputs
and two relays outputs available. The default setting is as follows:
PLC outputs
Relays outputs
To change these settings select the appropriate pin with the UP and DOWN arrows
on the left side of the display and afterwards select the desired command from the
list of commands with the UP and DOWN buttons on the right side of the display.
Press OK to save your settings. A screen with all selected settings will be displayed
for your reference. Confirm with OK again.
Pin Command Pin Command
4 Ready 16 Leak
5 not used 17 Error
Pin Type of contact Relay Output (default)
10 Currentless closed (NC) Leak
22 Common
23 Currentless opend (NO)
24 Currentless closed (NC) Ready
11 Common
12 Currentless opend (NO)
Fig. 4-22 Defining PLC outputs