User’s Manual
& Laser Safety Guide | 15
S3 Inferno
Series | 14
WWW.
WICKEDLASERS
.COM
Lens Cleaning
Procedure and Troubleshooting
What you need :
Microfiber Cloth -
Please make sure the
microfiber cloth is specifically designed
for cleaning lenses. You can find this at
your local camera or glasses store.
Q-Tip or Tooth Pick
- You will need to
fold the cloth over one of these in order
to be able to reach the lens properly.
Lens Cleaning Solutions
(Optional)
- Use the lens cleaning solution only
if the lens is not cleaned using the
microfiber cloth alone. Please make
sure the cleaning solution is designed
specifically for lens cleaning.
1.
2.
3.
Procedure :
Wash your hands with soap and water. Make sure to dry them properly.
Remove the batteries from your laser prior to cleaning.
Fold the microfiber cloth over a toothpick or the handle part of a Q-tip. Make sure
you do not touch the part of the cloth that will be cleaning the lens. You probably
will not be able to fold the cloth twice, so you need to be very careful not to press too
hard on the lens.
Gently move the cloth into the aperture until it comes in contact with the lens. Rub
it from side to side but do not press too hard. Gently rotate the cloth in a twisting
motion back and forth. Repeat this procedure until the lens of your laser is clean.
Re-insert the batteries and turn your laser unit on to see if the lens is clean.
Still dirty?
Apply only 1 drop of
Lens Cleaning Solution
to the part of the cloth that
will be cleaning the lens, the follow the same procedure as above. You will want to
finish by using a dry part of the cloth to wipe the lens dry, this should take one pass
side to side or gentle rotate.
1.
2.
3.
4.
5.
6.
!
WARNING :
DO NOT USE WATER
Dirty Lens -
The most common problem with your laser unit
is a dirty lens. The easiest way to determine whether you
have a dirty lens is to look at the lens under direct light. If
you see smudges, finger prints, or small particles on the lens,
the beam emitted will look similar to the above pictures.
Simply follow the cleaning instructions to restore the spot
back to a focused dot.
1.
Types of Common
Lens Problems
Scratched Lens -
A scratched lens may occur if you
accidentally scratch the lens with a hard or rough surface.
The lens of your laser unit is similar to that of a camera,
please handle with care. This condition can be repaired
by Wicked Lasers, however, will not be covered in your
warranty. A repair cost will apply.
2.
