C-COM Satellite Systems Inc.
Page 18 of 29
iNetVu
®
Fly-1202 User Manual
9)
Install Feed Arm after removing it from case. Align locking pin on Feed Arm Socket
with Feed Arm notch. Turn Feed Arm Captive Knob to fasten.
10)
Feed the IFL cable through the center of the AZ/EL drive and through the tripod
center same as was done with the Power/Data cable.
11)
Connect compass cable to compass quick connect connector coming from 7720
Remote Drive Module. Line up the pins of the connector and quick connect to avoid
damaging the pins.
12)
Connect Power/Data cable and IFL cable coming from 7710 controller to their
respective connections at base of antenna.
Indicates a situation or practice that might result in
property or equipment damage. Ensure Sensor, Motor
and RX/TX cables are all connected prior to powering
on 7710 Controller.
13)
Plug power cable into power source and power on the controller. There should be
no blinking or
RED
fields on the Controls screen on the iNetView application or on
LCD.
Captive
Knob
