Inepro V2, Technical Manual

Page: 34 / 47

26 - Inepro IP Reader V2
Software configuration settings
Name
Key Description
Name
The name of this IP reader (like 'Printer Q745') This name will also be used as
host name, it is sent to the DHCP server and DNS server if they are enabled.
IP config
Key Description
Dynamic Host
Configuration
Protocol
Enabled if DHCP be used, disabled if the network information need to be filled
out manually.
IP The IP-address for the IP reader.
Netmask
The netmask (only used when using subnetting, ask your system administrator,
if you're not sure). Standard value 255.255.255.0
Gateway
The IP address of the gateway (The gateway is de server that is located
between two networks, like the Internet and your local network). It is usually the
same address as the DNS server.
Domain Name
System The IP address of the server with the Domain Name System, the system that
transforms names to IP-addresses and vice versa.
Server config settings
Key Description
Server 1 IP The address of the server that the IP reader should contact.
Server 2 IP
The address of the back-up server that the IP reader should contact. It will be
contacted if the first server does not respond.
Server 1 name
When DNS is used the name of the server can be entered, the IP-address
value for this server will be ignored, and retrieved from the DNS server.
Server 2 name
When DNS is used the name of the server can be entered, the IP-address
value for this server will be ignored, and retrieved from the DNS server
Key set
Key set will give the possibility to set the encryption key between the IP reader
and the server. At the time of writing the value as not yet used and should
always be set to '1'.