inepro | pondweg 7 | 2153 PK Nieuw-Vennep | The Netherlands | +31 (0)252744044 | [email protected] | inepro.com
inepro.com
Converting a PayMatic AD2400 from coin acceptor to push button
Instruction
Page 2 of 2
PayMatic AD2400 (-B) -
Convert from coin
acceptor to button
4. The push button should be connected with the two wires of the coin acceptor. Remove the 2 wires of
the push button with the solder iron and solder the 2 wires of the coin acceptor on the pins of the
button. Note: It does not matter which wire is connected to what pin. Of course you should take
measures to prevent the two wires from short-circuiting.
5. Drill a hole with a diameter of 10 mm and mount the push button.
6. To block the coin acceptor entry a screw can be inserted.
7. Now the PayMatic can be closed again and it should be ready for use.