13
Operating the unit
Preparations before starting the grinding unit
1.
Make sure that mains rating corresponds to the data on the rating plate.
2.
Make sure the grinding unit is disconnected from the power source. If it is connected, pull
the plug out of the socket.
3.
Place the base or the worktable on a level, stable surface.
4.
Adjust the height of the table or the base to the height of the operator and the type of task
being performed.
5.
Place the unit in a stable position on the base.
6.
Check that the working wheel of the sanding belt moves freely (#10).
7.
Check that the power cord is not damaged.
8.
Check whether the sanding belt needs to be replaced (#4).
9.
Assess the completeness of the unit. Check that all covers of the moving parts are closed
and secured (#3, #6, #11)
10.
Check that the grinding support is in the desired angle and secured (#1, #2).
11.
Connect the power cable.
Safe operation procedures
1.
Ensure that
the section “
Preparations before starting the grinding unit
” is completed.
2.
Press the power button "I" to turn the unit on (#7). Wait for the motor speed to stabilize at
the maximum level after turning on the unit. Now you can start grinding.
Switch “ON”
Switch “O
FF
”
