5
PIL – 01DL
Detailed operating instructions are attached to the remote control.
The PIL-01DL remote has five buttons:
▲"up" button
■ "stop" button
▼ "down" button
Starting roller blinds:
To start the given drive, press the ▲ "up" button (to open) or the ▼ "down" button (to close). You can stop the
drive by pressing the ■ "stop" button at any time.
PIL – 05DL
Detailed operating instructions are attached to the remote control.
The PIL-05DL remote has five buttons:
▲"up" button
■ "stop" button
▼ "down" button
+ "plus" button
- "minus" button
Starting roller blinds:
To start the given drive, press the ▲ "up" button (to open) or the ▼ "down" button (to close). You can stop the
drive by pressing the ■ "stop" button at any time. After approximately 15 seconds of inactivity (no button pressed)
the remote will switch into "standby" mode (low battery power consumption). The remote is in "standby" mode as
standard, pressing any directional button will wake it and prepare it to work (it will display channel number, but no
other operation will be performed), the command will only be executed after pressing the button the second time.
Starting shutters:
To switch into the shutter mode (positioning slats) press and hold the - "minus" button or the + "plus" button for
approx. 3 seconds - the channel number will start flashing. To turn slats, press the ▲ "up" or ▼ "down" button.
Returning to normal operation mode is done similarly - press and hold the - "minus" or + "plus" button for approx.
3 s.
PIL – 09/19DL
Detailed operating instructions are attached to the remote control.
The PIL-09/19DL remote has five buttons:
▲"up" button
■ "stop" button
▼ "down" button
+ "plus" button
- "minus" button
Starting roller blinds:
To start the given drive, press the ▲ "up" button (to open) or the ▼ "down" button (to close). You can stop the
drive by pressing the ■ "stop" button at any time. After approximately 15 seconds of inactivity (no button pressed)
the remote will switch into "standby" mode (low battery power consumption). The remote is in "standby" mode as
standard, pressing any directional button will wake it and prepare it to work (it will display channel number, but no
other operation will be performed), the command will only be executed after pressing the button the second time.
Starting shutters:
To switch into the shutter mode (positioning slats) press and hold the - "minus" button or the + "plus" button for approx. 3 seconds -
3 horizontal lines will appear over channel number. To turn slats, press the ▲ "up" or ▼ "down" button. Returning to normal operation
mode is done similarly - press and hold the - "minus" or + "plus" button for approx. 3 s.