12|English
OPERATION INSTRUCTIONS
WARNING: Before using your angle grinder be sure
to read the instruction manual carefully.
1.
INSTALLING THE AUXILIARY HANDLE
(see fig 1)
An auxiliary handle is supplied and can be fixed into both of
the two positions on the gearcase. If you are right handed fit
the handle as shown in fig1. If you are left handed fit the
handle the other way round. When using a cutting disc, you
can screw the handle into the position on top of the
gearcase.
NOTE: This handle should be used at all times to maintain
complete control of the tool.
2.
ADJUSTING WHEEL GUARD (see fig 2)
Adjust the guard to protect your hands and direct grinding
debris. Loosen the screw. Position the guard at the required
angle. Then tighten the screw.
CAUTION: Be sure that the guard is secure before
starting the angle grinder.
WARNING: Never use the angle grinder without the
disc guard in place.
3. FITTING THE DISCS (see fig 3)
Place the grinding/cutting disc on top of the inner flange and
over the spindle. Ensure that it is firmly located on the raised
section of the inner flange. See fig3. Locate the outer flange
over the disc, making sure that the raised side is facting the
disc and is fully located in the centre hole of the disc.
NOTE: When clamping thin section metal diamond discs,
the outer flange must be reversed so that the flat/dished
side screws against the disc hub.
Press and hold down the spindle lock button and tighten the
outer flange using the two pin locking wrench. It may be
necessary to turn the spindle to fully locate the spindle lock
button.
When the outer flange washer is tight, release the spindle
lock button and remove the wrench.
Screw
Spindle
