page 6
IDEX
400
SATA - Installation & Operation
indus
technologies
insTallaTion insTrUCTions
These.instructions.assume.the.computer.is.setup.for.SATA.only.(.no.IDE.drives.).
Static Caution:
Before.removing.any.parts.from.protective.static.bags.ensure.that.you.have.taken.proper.precautions.to.prevent.damage.
from.static..A.static.strap.should.be.worn.at.all.times.
1. Set IDEX 400 Jumpers
If.you.are.using.the
IDEX 400
.as.a.stand.alone.unit.(.in.“Local.Mode”,.no.
Master Selector
.).remove.all.jumpers.
The.“Master.Mode”.jumper.setting.allows.the.
IDEX 400
.to.be.controlled.remotely.by.a.
Master Selector
..The
“Local”.and.
“Drive.1”.default.jumpers.determine.what.the.drive.selector.will.do,.if.an.invalid.signal.from.the.
Master Selector
.is.detected..
This.could.occur.if.the.
Master Selector
.is.faulty.or.if.the.cable.from.the.
Master Selector
.is.disconnected..If.no.jumper.is.
placed.on.the.“Local”.or.“Drive.1”.positions,.no.drive.will.be.selected.
Master Mode
.
This.mode.is.used.when.the.drive.selector.is.being.controlled.by.a.remote.
Master Selector
..
In.this.mode.the.
IDEX 400
.will.activate.the.drive.set.by.the.
Master Selector
..If.the.signal.from.the.
Master Selector
.is.not.valid.the.logic.will.activate.the.“Default.Drive”..“Master.Mode”.is.set.by.placing.
one.jumper.on.the.“Master.Mode”.position.as.shown.
Local
.
When.the.jumper.is.place.on.this.position,.the.drive.is.selected.by.the.
IDEX 400
.and.will.be.
activated.if.there.is.a.problem.with.the.signal.from.the.
Master Selector
..
Drive 1
.
When.the.jumper.is.place.on.this.position,.“Drive.1”.will.be.activated.if.there.is.a.problem.with.the.
signal.from.the.
Master Selector
..
Jumper Pins
■ ■
Master.Mode
■ ■
Drive.1
Default
■ ■
Local
■ ■
Master.Mode
■ ■
Drive.1
Default
■ ■
Local
■ ■
Master.Mode
■ ■
Drive.1
Default
■ ■
Local
Master.Mode:.
Drive.1
Local.Mode
Master.Mode:
Local.Select