OPERATION
1
Install by screwing the head
clockwise onto the 3/8" mounting
thread of monopod plate. Once it is hand
tight, secure by fully tightening the
three head locking screws from below.
2
When used properly, the patented
dual lock quick release system
offers two levels of security for your
gear. To remove the quick release
plate, squeeze both the Plate Locking
Lever and the Security Locking Lever
and pull the larger locking lever out.
The Quick Release Plate will disengage
allowing it to be removed.
3
To reconnect the Quick Release
Plate, insert the angled part
of the plate into the groove on the
opposite side of the locking levers and
press down flat. The locking levers
will automatically engage the locking
system and will return to the safety
lock position. Press the Plate Locking
Lever in firmly to secure.
4
Horizontal rotation or panning
can be easily accomplished by
swiveling the entire monopod.
5
Front to rear angle or tilt
adjustments can be easily
accomplished by first loosening the
Tilt Lock Knob (be sure to hold firmly
to balance weight of the camera).
Position as desired and tighten the
knob securely.
6
Depending on your requirements,
you may find it convenient to reorient
the camera or lens 90 degrees on the
Quick Release Plate and then remount.
This allows the Tilt Control Knob to give
you different positioning support.