Indumicro IMP-A120, User Manual, Page: 28 / 54

Three options are available for Power Management, including two fixed modes.
User Define (default) Allows you to set each mode individually. When not disabled, each of
the ranges is from 1min to 15min.
Min Saving Minimum power management. Suspend Mode=1hr and HDD Power
Down=15min.
Max Saving
Down=1min.
Video Off Method
This item determines the display type of monitor.
V/HSYNC+Blank This option turns off the vertical and horizontal synchronization ports and
writes blanks to the video buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS (default) This option controls initial display of power management signal.
Video Off In Suspend
This item determines the display type to be cleared by monitor.
Options are:
Yes (default)
and No.
Suspend Type
This item is used to select suspend type. Options are: PWRON Suspend and Stop Grant (default).
Modem Use IRQ
This item determines the IRQ used by Modem.
Options are:
3 (default)
, 4, 5, 67, 9, 10, 11 and NA.
Maximum power management. Suspend Mode=1min and HDD Power
Chapter 2 : BIOS Setup
When enabled, after the set time of system inactivity, all devices except the CPU will be shut off.
Options are: 1/2/4/8/12/20/30/40Min, 1Hour and
Disabled (default) .
HDD Power Down
When enabled and after the set time of system inactivity, the hard disk will be powered down
while all other devices remain active. Options are: 1/2/3/4/5/6/7/8/9/10/11/12/13/14/15Min and
Disabled (default).
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the Soft-Off state.
Options are: Delay4Sec and
Instant-Off (default).
Suspend Mode
IM P -A 1x 0 T User Manual
25