INSTINCT User Manual rev 01 04/18
29
Section 3
Operation
Control
TURN UNIT ON
Click knob and turn to select power level.
LED RING
• The LED ring flashes if operator input is need-
ed.
• The LED ring lights up continuously during
cooking or holding.
SWITCHING BETWEEN COOKING AND
HOLDING MODES
Holding mode is not available for INSTINCT Wok.
1. During operation, click knob once. The LED
flashes.
2. While watching the display, turn knob clock-
wise or counter-clockwise to activate Power
Level Mode or Hold-Mode.
3. Click knob again to confirm selection.
SETTING POWER LEVEL (1 TO 12) AND
LOCK/UNLOCK
1. In Power Level Mode, turn knob clockwise to
choose power level:
•
Power level (1) = lowest power
•
Power level (12) = highest power
2. To lock power at set level, press down knob
until the word “LOCK” on the display lights
up. This takes 2 seconds.
3. To unlock, press down knob again until the
word “LOCK” on the display goes dark. This
takes 2 seconds.
Power Level Settings
The Power Diagrams (below) show that the dif-
ference in power output between two higher
power levels is much larger than that between
two lower power levels.
This power level and output relationship gives
you a fine simmer-rate control in the low power
range, and an instant response in the high power
range.
POWER DIAGRAM 1: POWER LEVEL 0 TO 12
POWER
OUTPUT
0
1
2
3
4
5
6
7
8
9
10
11
12
P O W E R LEVEL
100%
50%
10%
20%
30%
40%
60%
70%
80%
90%
The settings from (1) to (9) span the lower
50% of the total Power Output; the settings
from (10) to (12) cover the 50% to 100% out-
put range.
SELECTING HOLD TEMPERATURE AND
LOCK/UNLOCK
1. In Hold-Mode, turn knob until the desired
temperature is shown on the display.
2. Leave the knob for approximate 5 seconds,
the display will show the actual detected
temperature.
3. To lock temperature at set level, press down
knob until the word “LOCK” on the display
lights up. This takes 2 seconds.
4. To unlock, press down knob again until the
word “LOCK” on the display goes dark. This
takes 2 seconds.