CS3000 INDUCTION RANGE
FAULT FINDING
Induced Energy Limited
Westminster Road, Brackley, Northants NN13 7EB United Kingdom
Tel: 01280 705900 Fax: 01280 705270 email: [email protected] website: www.inducedenergy.com
Display
What it means
Necessary action
Likely causes
No Pan
Present
There is no pan on
the ring
Place a suitable pan on the hob.
Either no pan is present on the hob,
the pan is smaller than the inner ring
on the hob surface, or the pan is not
suitable for induction.
Clean filter
The inside of the hob
is too hot
Turn knob fully anticlockwise to ‘--’
and leave for 10 mins. Turn hob
on again
Check that air filter is clean -
see 6. above
Check that fan is working
Glass is hot
The glass is over 80C
The glass immediately under the pan
will become hot during use
This is a safety notice and
NOT A FAULT.
Shut down
The hob has sensed
an unusual condition
Turn knob full anti-clockwise to ‘--’,
then slowly back to its original setting
There will be an error code number
in the power setting display –
see below
Glass is hot/
Shutdown
(alternating)
The hob has detected
an unacceptably high
internal temperature
Caution - the top may be very hot.
Remove the pan. Turn the hob power
setting to 0 and leave it to cool for ten
minutes. (The hob should still be
switched on to allow the fan to cool
the unit) Switch the hob to the --
power setting (the fan will switch off)
and then resume normal operation.
All Digits
Flashing
(CS3000G
CS3000QB
CS3000QT only)
Lid safety inhibitor
activated
Push lid securely back into place
Lid disengaged during filter cleaning.
See Section 6 above.
01
Mains voltage error
Turn the knob full anti-clockwise,
and then advance it clockwise
High or low mains voltage - electrical
supply requires investigation.
02
Electronic overload
Turn knob fully anti-clockwise to ‘--’,
then slowly back to its original setting
May happen infrequently in
normal use. Try a different pan.
03
Electronics
Overtemp
Turn knob fully anti-clockwise to ‘--’,
then slowly back to its original setting
Probable cause is a blocked air filter.
Clean the filter - see section 6
04
Coil Overtemp.
Turn knob fully anti-clockwise to ‘--’,
then slowly back to its original setting
Extended use of a griddle or wok can
cause this. Alternatively a blocked air
filter – see section 6
05
Electronic sensor
malfunction
Turn knob fully anti-clockwise to ‘--’,
then slowly back to its original setting
If re-setting does not clear the
indication, the hob must be returned
for repair.
06
Coil sensor
malfunction
Turn knob fully anti-clockwise to ‘--’,
then slowly back to its original setting
If re-setting does not clear the
indication, the hob must be returned
for repair.
9.
FAULT FINDING
In the unlikely event of a fault, please consult the following table:-
