[93] - Brightness of the image
If required the brightness of the image can be adjusted.
Press the brightness button to adjust the brightness, which is represented in bars.
when
the speech button [17] is activated
!
Default setting: 2 bars
[94] - Activate / deactivate cameras 2-4
[82] - RECORDER SETUP(see Fig. G)
[95] - 24 hour RECORD SCHEDULE (Select time and method of recording)
[96] - MOTION DETECTION SENSITIVITY
!
#
#
!
#
#
#
!
#
#
#
#
#
#
#
#
#
#
#
#
Press the activation button to activate (ON – image of the paired camera will be shown) or to deactivate (OFF – image of the paired camera will
not be shown).
Camera 1 cannot be deactivated, it is always active.
The image from a paired camera which is deactivated will not be displayed nor will it be recorded.
press [99] in the top bar.
M=MOTION: cameras 2-4 can be recorded automatically upon motion detection, manual recording of all 4 cameras is also possible (only
activated cameras 2-4 can detect motion, the camera in the outdoor station does not have this function)
S=SCHEDULE: all four cameras can be recorded continuously
X= MANUAL recording can be started only by pressing the record button
firstly select X=MANUAL [99]. Now you can select the recording type for each hour
period [100] by repeated pressing:
M= cameras 2-4 can be recorded automatically upon motion detection during the hour period, manual recording of all 4 cameras is also
possible
S=SCHEDULE: all four cameras can be recorded continuously during the hour period
X= MANUAL recording can be started only by pressing the record button
Motion is detected by software analysis of pixel changes within the activated areas of the camera image.
Recordings can only be made from activated cameras.
During recording the symbol [5] indicates which camera also has audio recording. For the recording of audio from additional cameras it is
important, which image is selected: If quad or full image of the outdoor station selected, the audio from the outdoor station will be recorded
. If the full image of a camera 2-4 is selected, then the audio of the selected camera will be recorded. For motion
detection activated recordings the audio is recorded from the camera which triggered the recording.
The recording period after motion detection is approx. 2 minutes. Continuous recording is made in files of 10 minutes, ie. During one hour period
there will be 6 recordings each of 10 minutes length. Note that if the ring recording is deactivated no further recordings can be made when the
micro-SD card has reached its capacity.
If continuous or motion detection recording has been set, then after exiting the menu the message “REC RESUMES IN 4 SEC” indicates that
recording is possible after a setting period of 4 seconds.
When a recording begins a message appears “REC IN PROCESS WAIT 14 SEC”. Only after 14 seconds have elapsed can the recording be manually
stopped.
To stop a continuous or motion detection recording, open the control bar by pressing the [15] symbol, press the record button [21] and then
immediately afterwards the menu button [22]. Now you are in the main menu. and can change the recording settings. If you leave the main menu
without changing the settings, the recording will recommence immediately.
During recording (flashing red dot [9]) it is not possible to open the main menu. To open the menu proceed as in the previous note.
During continuous or motion detection recording the manual Zoom function is not available.
For each camera 2-4 you can select how sensitive the pixel changing must be to trigger a recording.
Default: cameras 2-4 OFF
Default: all cameras can be recorded manually only, for all 24 hours.
Default: cameras 2-4: 2 bars
Note:
To set the same recording schedule for all 4 cameras,
To set the recording type for each individual hour period,
Notes:
This time plan is valid for all cameras and for every day.
g
GB - 49