Index MS16-6, Operating Instructions Manual

Page: 30 / 82

AM080 - Clean and lubricate chucks
Orientation
To ensure reliability and accuracy of the machine, chucks must be subjected to
periodic maintenance.
The interval of this maintenance is strongly influenced by the type of material and
daily production time. Especially for short chipping materials (e.g., brass or cast
iron), these maintenance activities must be performed much more frequently.
Due to different requirements and/or specifications of the respective
manufacturers, be sure to review the respective manufacturer's
documentation!
Depending on the materials to be machined (e.g.: brass, cast iron)
and the number of shifts per day, more frequent cleaning of the
chuck is necessary.
For this, the chucks must be removed and completely cleaned.
Requirement
Do not use cotton waste for cleaning.
When cleaning with cotton waste, fibers or thread can get loose
causing safety problems.
Procedure
1.
Caution
Sharp contours on the clamping device
Cuts
Use personal protective equipment (e.g., protective gloves)
Clean chuck.
2. Lubricate chuck according to manufacturer’s instructions.
3. Remove, wash and oil chuck.
4. Clean chuck/collet of synchronous device (if necessary completely remove)
and lubricate (observe the manufacturer's instructions).
Maintenance Summary - Care activities
26
Maintenance Instructions
MS32-6.2
DIM012EN - 03.06.2020