Index Braille
Index 4X4 PRO
Page 26
January 2000
Version 1.20
7.6
Fault messages
7.6.1
Failure No reference-pulse
Turn the embosser OFF/ON. If you still get the same message, contact your service distributor.
7.6.2
Failure Paper length fault
This fault appears when the paper is to short compared to the measured paper length or if the paper is
dark coloured.
1. Press
ON LINE
to eject the paper and print a new copy of the current page.
7.6.3
Failure Paper jam
This fault appears when the paper is to long comparing to the measured paper length.
1. Press ON LINE eject the paper and to print a new copy of the current page.
2. If there is serious paper jam due to i.e. multiple feed etc., press FORM FEED key to eject the
paper out of the system. The embosser will now use a reduced speed with high torque to eject the
paper slowly out of the embosser. If there should be a problem getting the paper out of the
embosser, use the FF key to toggle FF OFF/ON. When the paper is ejected, press ON LINE to
cancel the FF operation.
7.6.4
Failure 140 - invalid setup command
Not a valid command when selecting A, B or C from computer.
7.6.5
Failure invalid setup value
If there is a an invalid numeric value in the setup file, the embosser will echo i.e. “Fail item Baudrate,
Value 10”.
7.6.6
Failure 160 - EEPROM failure
Major fault in EEPROM. Contact your service distributor!
7.6.7
Failure 170 - Text buffer exceeded
Error message if pressing REPEAT key, and file is larger than the available buffer. Repeat command is
not accessible.
8.
Serial communication cables
8.1
Serial cable 4X4 PRO - IBM computers
There is a standard cable between the 4X4 PRO and the PC. On the 4X4 PRO side a 9 pin male D-
sub and on the PC side a 25 or 9 pin female D-sub. Cable with the following wires.
4X4 PRO - 25p D-sub.
4X4 PRO - 9p D-sub.
2-2, 3-3, 4-6, 5-7, 6-20, 7-5, 8-4
2-3, 3-2, 4-6, 5-5, 6-4, 7-8, 8-7