10
EN
Options
The options allow for customising the selected programme according to ones own needs.
Delay timer
The start of some programmes
(see Programmes and options)
may be delayed up to 9 hours. Press the button repeatedly to
enter the desired delay time. Before setting a delayed start, make sure that the water container is empty and that the filter is clean.
Post Care
When this option is selected, the drum rotates garments at intervals after the cold drying cycle has ended, in order to avoid
creases forming on garments if they cannot be immediately removed at the end of the programme. During this phase, the indicator
light is turned on.
Pre Care
When this option is selected in addition to the Delay timer option, the drum rotates garments at intervals during the delay period
to avoid creases forming.
High Heat
When a drying time is selected, pressing this button sets high heat drying and the indicator light above the button lights up. The
timed programmes are pre-set to low heat.
Not all options are available on all programmes
(see Programmes and options)
.
Opening the door
If the door is opened (or the START/PAUSE button is pressed) while a programme is running, the dryer stops and the following
may occur:
The START/PAUSE button flashes orange.
When a delayed start is running, the delay countdown continues. It is necessary to press the START/PAUSE button to resume
the Delay timer programme. One of the Delay timer indicator light flashes to signal the delay time entered.
It is necessary to press the START/PAUSE button to resume the programme. The progress indicator lights signal the running
phase and the START/PAUSE indicator light stops flashing and turns green.
During the post care phase, the programme ends. Pressing the START/PAUSE button reactivates a new programme from the
beginning.
By turning the Programme selection knob, a new programme is selected and the START/PAUSE indicator light flashes green.
This procedure can be used to select the Cold drying programme to cool garments if they are judged to be dry enough.
Press the START/PAUSE button to start the new programme.
Note:
In the event of a power cut, turn the power switch off and remove the plug; when the electricity supply returns, press the
START/PAUSE button to resume the programme.
Summary of Contents for IDCA 8350 B
Page 19: ...EN 19 ...
Page 20: ...20 EN 195089408 00 11 2010 ...
