Indesit DG 6145, Installation And Use Manual

Page: 8 / 16

6
GB
Turning on the Appliance
Starting a wash cycle....
1. Make sure that the plug for the appliance is inserted into
the wall socket.
2. Make sure that the water supply is turned on to full
pressure.
3. Load the dishwasher (see the section entitled, "Loading
the Dishwasher").
4. Pour in the detergent (see the section entitled, "Salt,
Detergent and Rinse Aid").
5. Turn the knob located on the right of the control panel in
the clockwise direction until the number or symbol for the
cycle setting is aligned with the reference mark (see the
section entitled, "Wash Cycle Table").
6. Press the ON-OFF botton, and the ON-OFF light will turn
on. At this point, the wash cycle will begin.
Cancelling or modifying a wash cycle setting...
Premise: A cycle that is underway can only be modified if it has
only been running for a short time. Otherwise, the detergent
may have already been used, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser
must be refilled (see the paragraph entitled, "Loading the
Detergent").
Press the ON-OFF button, and the ON light will turn off.
Rotate the knob in the clockwise direction to the desired
cycle setting (see the section entitled, "Starting a wash
cycle..."). Then, turn the dishwasher back on using the ON-
OFF button.
If you forget to load some of the dishes...
The wash cycle can be interrupted by pressing the ON-OFF
button. You can then load additional dishes and turn the
appliance back on. The cycle will start where it left off.
At the end of the wash cycle...
When the knob stops turning and is aligned with a STOP
mark (see figure), the cycle has finished. Turn off the
appliance using the ON-OFF button, turn off the water supply
and open the door of the dishwasher.
Wait a few minutes before unloading the dishwasher to
avoid handling the dishes and utensils while they are still
hot and more susceptible to breakage. They will also dry
better.
1
2
3
4
STOP