inDESIGN IDX-12FX, Owner'S Manual

Page: 8 / 17

iDX-FX SERIES: OWNER’S MANUAL PAGE 8
25. AUX 2
This is normally derived after the EQ and channel fader
(POST FADER, POST EQ) and therefore follows any changes in
fader level. They are normally used to drive effects processing
units which are fed back into the mixer and which must fade out
with the input channel.
26. PAN
The pan control sends continuously variable amounts of the post
fader signal to either the left or right and G1, G2 main busses. In
the centre position equal amounts of signal are sent to the left
and right or G1, G2 busses.
27. STEREO L-R
Push the switch and the channels signal is routed
to the ST L-R fader.
28. G1-2
Push the switch and the channels signal is routed
to the G1-2 fader.
29. CHANNEL FADER
This is function to adjust the volume of signal connection
into each channel and adjust the volume of output, together
with master fader. Normal operating position is at the “0” mark
and can also provide an extra 4dB of gain above that point,
if required.
30. PEAK
Top (red) LED indicates a signal level at the insert return
point, premaster fader. It illuminates at approximately 7dB
below clipping.
31. PFL
You can monitor the signal of a channel when this switch is on
by using a separate headphone. When the PFL switch is on, the
other channels mute automatically in the headphone mix. The
LED will illuminate when engaged.