ENGLISH
SRKSMART115V_11-01-2018
21
K BASIC - K SMART - K ECOSMART 115V
INSTALLATION
To install the Minibar properly, you must ensure the air supply to the refrigerating unit making openings for
air inlet and outlet as shown on the following figure.
VENTILATION
The compressor cooling system lets out heat and needs good ventilation. Therefore places with bad ventila-
tion are not very suitable. The Minibar must be installed in a place with an opening which guarantees
the necessary exchange of air, and it is of the utmost importance not to cover up or obstruct the grids
which provide the device with proper ventilation. One must also avoid positioning it in a place which
is directly exposed to sunlight or to other heat sources.
FREE CROSS SECTION 200 cm
2
For the built-in models, you must fit the Minibar into the cabinet,
guaranteeing a cross section at the air inlet and outlet of
at least 200 cm
2
, equal to a height of mm. 48 by the width
of the refrigerator. Leave 60 mm free between the Minibar
and the furniture on the top, left and right sides.
Summary of Contents for K BASIC 115V
Page 2: ......
