2
AUSTRALIAN STANDARDS COMPLIANCE
WARNING: TO PREVENT FALLS THE MATTRESS BASE
OF THIS COT SHOULD BE ADJUSTED TO THE
LOWEST POSITION BEFORE THE CHILD CAN SIT UP
RECOMMENDED MATTRESS SIZE: 700 MM
WIDE X 1310 MM LONG X NO MORE THAN
120 MM THICK
Failure to follow these warnings and the assembly instructions could result in serious injury or
death.
Before each usage or assembly, inspect cot for damaged hardware,
Loose joints, missing parts or sharp edges. Do not use cot if any parts are missing or broken.
Ask your dealer or contact incy interiors for replacement parts and instructional literature if
needed. Do not substitute parts.
When child is able to climb out or reach the height of 90 cm, the cot shall no longer be used.
Do not place cot near window where cords from blinds or drapes may strangle the child.
If refinishing, use a non-toxic finish specified for children’s products.
Do not use a water mattress with this cot
Upon completion of assembly, be sure all screws and bolts have been tightened securely.
A periodic check should be made of all screws and bolts and retightened if necessary.
Never use plastic shipping bags or other plastic film as mattress covers because they can cause
suffocation.
Do not drag cot.
After cot has been completely assembled, store instruction sheet in this pouch.
Under no circumstances should this warning be removed from mattress support!
WARNING: TO PREVENT FALLS, THE
MAXIMUM MATTRESS THICKNESS SHOULD
NOT EXCEED 120 MM.