INCRA
IBOX
OWNER’S MANUAL
©2020 by Taylor Design Group, Inc. All rights reserved.
Page 5
2. Attach IBOX to GlideLOCK™ Miter Bar
Assembly
Position the IBOX fence on the GlideLOCK™ Miter
Bar Assembly with the red knob on the LEFT end of
the IBOX fence. Insert the (2) #10-24 x 3/8” button
head fasteners through the slotted holes in the fence
and thread into the holes on the GlideLOCK™ Miter
Bar. Don’t tighten the fasteners just yet. Slide the
IBOX along the alignment plate until the tall notch on
the fence is centered on your router’s collet, Fig. 6 and
Detail 6A. The center is 9/16” from the edge of the
notch if you would like to use a ruler for the alignment.
Make sure that the IBOX is firmly in contact with
the alignment plate on the GlideLOCK™ Miter Bar
Assembly then tighten the (2) button head fasteners to
secure the fence to the bar. If you move the IBOX to
another router table or your table saw, you will need
to reset the Miter Bar’s position as described in Steps
1-2 above for the router table or steps 1-3 on page 3
for the table saw.
Fig. 6
Attach IBOX to Miter Bar
Alignment
plate
2) Secure fence
against alighment
plate and tighten (2)
fasteners
Detail 6A
1) Slide fence to
center tall fence
notch on router
collet
STOCK LEDGES, BLADE GUARDS & BACKING BOARD
In the following steps you’ll add the Stock Ledges, the Blade Guards and the Backing Board. The photos show the
table saw set up but the steps are identical for the router table.
1. Attach Stock Ledges
Insert the (2) #10-32 x 5/16” flat head
Phillips screws through the countersunk
holes in each stock ledge and loosely
thread on the #10-32 rectangular nuts.
The raised rim on the rectangular nuts
should be facing the stock ledge. Slide
the rectangular nuts into the T-slot
on the front of the IBOX fence. For
now, align the ends of the stock ledges
with the wide cutout in the fence and
tighten all (4) fasteners, Fig. 7.
Fig. 7
Attach Stock Ledges
Stock ledge
Securely tighten
all (4) fasteners
#10-32x5/16” flat
Phillips with
rectangular nuts
Align ends with
wide cutout in
lower part of
fence
