Pairing it-Switch with it-Receive (for computer
connection)
1. Ensure the it-Receive is connected to your computer.
2. Place the it-Switch close to the it-Receive (within 1 metre).
3. Press and release the PAIR button on the front of the it-
Receive. The red light next to it will begin flashing.
4. Within 10 seconds press and release the PAIR button on the
it-Switch.
5. The light on the it-Receive will continue to flash while the
devices communicate with each other.
6. Once the pairing is successful the red light on the it-Receive
will stay on for 5 seconds.
7. If the light continues to flash for 30 seconds and then stops,
repeat the process above. If it still does not pair successfully,
refer to the Troubleshooting section.
8. If pairing two it-Switches, repeat the process above for the
second switch.
Pairing information is retained in the it-Switch’s memory even
after changing the batteries.
Operation with it-Receive
To enable the it-Switch to interact with software on the computer,
the correct mode will need to be selected. The mode is selected
by pressing the MODE button on the underside of the it-Switch.
The mode is shown on the display as a number (0-9) or letter
(A-H). The table overleaf shows the function for each mode.
Repeated pressing of the MODE button will cycle through 0-9
then A-H, then back to 0.
