6
3. Configuration
: Make sure the floats are in the position
shown above before power is applied.
After power is turned on, the software boots up (may take 2
to 3 minutes). When the software has successfully started,
you will hear:
if there is
no
configuration assigned: 2 beep sounds
if there
is a
configuration assigned: 4 beep sounds
followed by a single long beep sound.
After about one minute, the control unit is in configuration
mode. While the controller is in this mode – waiting for
configuration mode to be activated – you will hear 2 beep
tones every 5 seconds.
The software remains in this loop until the configuration
mode is activated
If you can’t hear any signal tone even after 2 minutes have
elapsed, please check the integrated fuse of the control (see
chapter 2.3.).
4. Activating the configuration mode
SS1-floater = down & at the same time
SS2b-floater = down
for 5 seconds
Control ends the start of the configuration mode with 3 short
“beep, beep, beep”.
Then, depending on the filter type and the type of
installation, the mode is set with the float switch SS1.
5. Configuration of filter and installation type
move the floater SS1
within 30 seconds
• 1 x up & down = drum filter - gravity setup
(with warning sounds)
• 2 x up & down = drum filter - gravity setup
(without warning sounds)
• 3 x up & down = drum filter - pumped setup
(with warning sounds)
• 4 x up & down = drum filter - pumped setup
(without warning sounds)
• 5 x up & down = endless belt filter - gravity setup
(with warning sounds)
• 6 x up & down = endless belt filter - gravity setup
(without warning sounds)
• 7 x up & down = endless belt filter - pumped setup
(with warning sounds)
• 8 x up & down = endless belt filter - pumped setup
(without warning sounds)
Each movement of the float is confirmed with a beep tone.
After the 30 seconds the selected configuration is active, the
control confirms the configuration with a short beep and a
long beep.
Disconnect the power supply to the controller and install
the float switches in the filter (see chapter 9). Subsequently,
the controller can be put into operation.
If you are unsure about the configuration, restart it
beginning with step 1.
Tip: Quick configuration of the control for the setup type
“drum filter - gravity setup (with warning sounds)”
Disconnect the power supply to the control.
Position the floaters as shown on the right.
Connect the control to the power supply.
Do not move the floaters for 2 to
3 minutes!
During the waiting time, you will hear
several beeping sounds with different
duration.
When the configuration is complete,
you will hear a short beep every 5
seconds.
Disconnect the power supply to the control and install the
float switches in the filter (see chapter 9).
Subsequently, the control unit can be put into operation.
!
ATTENTION: If you configure the control unit
with the app, you can proceed directly with
step 3.1.
2.7. Configuration of the control
without App or WLAN
For the configuration of the
control without app, we
recommend the following
procedure:
1. Connect both float switches to
the control unit
2. Position the floaters as shown
!
