EN
39
#3
PUSH THE PISTON
Push piston 1
using the Allen wrench
provided on the back of the trigger
until
the hole in the piston is aligned with
the hole in the trigger.
#4
INSTALL THE PIN
Place the release pin in the piston hole,
ensuring that it is firmly seated.
While holding the pin in place with
your thumb, screw the cap back on
until the arrow on the cap and the arrow
on the trigger are aligned.
#5
FIT THE NEW RECHARGE
Fit the new recharge: Insert the new
recharge by clipping it onto the trigger.
Then put the elastic back on to hold it
in place.
CAUTION: Please make sure that
the hole in the piston is of a “metal”
colour. If the hole is black, the piston
has not been pushed in properly.
CAUTION: The piston may have
rotated around its axis. If the hole in
the piston is not visible, please use
the Allen key to orientate the piston
properly.
Still using the Allen wrench, push pistons
2, 3, and 4 into their seats.
