7
INSTALL INLET PIPE
1. Connect the elbow to tap and fasten it clockwise.
2. Connect the other end of inlet pipe to the inlet
valve at the backside of washing machine and
fasten the pipe tightly clockwise. Notes: after
connection, if there is any leakage with hose,
then repeat the steps to connect inlet pipe. The
most common type of tap shall be used to supply
water. If tap is square or too big, then standard
tap shall be changed.
→
HOLE PLUG
This Hole plug is used to jam the hole on the back
cabinet.
→
PLACE OUTLET HOSE
There are two ways to place the end of outlet hose:
1. Put it beside the water trough.
→
2. Connect it to the branch drain pipe of the
trough.
→
Max.100cm
Min.60c
m
Position outlet hose properly so that the floor will not
be damaged by water leakage.
NOTE:
If the machine has outlet hose support, please install
it like the following pictures.
1.
→ When installing outlet hose, fix it properly with
a rope.
→ Position outlet hose properly so that the floor will
not be damaged by water leakage.
2.
Trough
Hose Retainer
Bind
Max.100cm
Min.60cm
Min
.60c
m
Ma
x.100c
m
→ If outlet hose is too long, do not force it into
washing machine as it will cause abnormal
noises.
ELECTRICAL CONNECTION
As the maximum current through the unit is 10A
when you are using its heating function, please make
sure the power supply system (current, power voltage
and wire) at your home can meet the normal loading
requirements of the electrical appliances.
→ Please connect the power to a socket which is
correctly installed and properly earthed.
→ Make sure the power voltage at your place is
same to that in the machine’s rating label.
→ Power plug must match the socket and cabinet
must be properly and effectively earthed.
→ Do not use multi-purpose plug or socket as
extension cord.
→ Do not connect and pull out plug with wet hand.
→ When connecting and pulling out the plug, hold
the plug tightly and then pull it out. Do not pull
power cord forcibly.
→ If power cord is damaged or has any sign of
being broken, special power cord must be
selected or purchased from its manufacturer or
service center for replacement.
