SmartNode SN2300 Hardware Description
21
3 SMARTNODE
SN2300
HARDWARE
DESCRIPTION
The SN2300 is a powerful multi-service access device. The 19in aluminum chassis can be rack-
mounted, and provides three expansion slots for interface cards. The SN2300 complies with all
relevant EU directives.
3.1 Physical
Description
•
Chassis W/H/D 440 / 42 / 265 mm
•
Weight 1650g
•
CPU Motorola MPC860 @ 50 MHz
•
Memory 16 MB SDRAM
•
Flash 4 MB
•
Power dissipation 30 W, fully loaded interface card (IC) slots, without internal 48V (or 38V)
Line Power Module PM-48V-int (or PM-38V-int)
•
Power supply AC 100 - 240 V, 50/60 Hz , max. 1.0 A
3.2 Front
Panel
The front view of the SmartNode 2300 is depicted in Figure 3-1 below.
Figure 3-1: SmartNode SN2300 Front View
•
Three front LEDs (’PWR’,’RUN’, and ’ACT’) indicate the status of the device.
See Chapter 11, “Led Indications”, for detailed information on the LED states.
3.3 Rear
Panel
The rear view of the device is depicted in Figure 3-2. There are three expansion slots for optional
interface cards, and four board-mounted sockets. Three LEDs ’Status’, ’LINK’, ’100Mb/s’) indicate the
status of the on-board interfaces. See Appendix A for cabling connections and pin out data.
Figure 3-2: SmartNode SN2300 Rear View
3.4
Expansion Slots
Three slots, labeled SLOT 1 - SLOT 3, accept different PMC interface cards to integrate voice and data
over IP networks. The interface cards and their ports are described individually later in this Guide.
3.5 On-Board
Ports
Three motherboard-mounted network interfaces are available for use, independently of those, which
are available with interface cards mounted in SLOT 1 - SLOT 3. The motherboard-mounted ports are
tabulated in below. The Port column of the table shows the port’s label and the interface type.
Hardware Installation Guide, Revision 3.11
Summary of Contents for SmartNode 1000 Series
Page 2: ......