800-446-7488
9
www.in-situ.com
Setting Up a Log
The Cube logs data from instruments directly to the internal SD card. How and when the data is recorded is configured using the
Cube set up tool.
If you require data redundancy, program a log on your instruments prior to connecting them to the Cube. Some instruments do not
support logs.
Refer to your instrument manual for instructions on setting up a log.
Configuring the Telemetry Device
Overview
If you purchased a data plan through In-Situ, you need to open the unit and connect the battery, and then set up the Cube using the
configuration software.
If you are using a 3rd party data plan, you will need to install the SIM card prior to setting up the Cube with the configuration
software. See "SIM Card" on page 19.
Opening the Unit
1. Place the unit on a flat surface.
2. Remove the fourscrews from the cover of the unit and remove the cover.
3. Remove the four screws from the top panel. Push down on the left side of the panel.
Battery
Cube 300S systems have a nickel-cadmium battery pack (PN 0062290) that is rechargeable via solar panel or using the battery
charger. Batteries are installed but not connected prior to shipping.
To connect, disconnect, or change a battery pack, follow the steps below.
1. Ensure an antenna is attached to the unit.
Never connect or disconnect power to the unit without an antenna attached.
