5
PowerLED Analog Dimmer Module
The ILIM80200 PowerLED Analog Dimmer Module is
used for automated control of a circuit of PowerLED
Lights. The ILIM80200 PowerLED Dimmer Module
can interface with any control system that can provide
a 0-10VDC Analog signal. Before making any
connections, be sure all power in the circuit is turned
off at the breaker. To install your PowerLED dimmer, connect the wires
according to the following schematic. Failure to follow the wiring schematic
exactly as shown will result in failure & permanent damage to the dimmer.
Note:
The ILIM80200 PowerLED Dimmer Module requires a 0-10VDC
signal source. It does not provide a 10VDC voltage to be
modulated and returned.
A 0V signal input will render a 0% light output.
A 10V signal input will render a 100% light output.
0-10V Analog
Signal Source
Imtra
PowerLED
Voltage Supply
(battery, converter, etc)
Control System
0-10V Analog
Control Unit
Imtra
PowerLED
(+)
(-)
To other PowerLEDs
(up to 30 total)
ILIM80200
Dimmer Module
6
PWM Control of PowerLED Lights
Imtra PowerLED Lights can also be controlled with a Pulse Width
Modulating signal. Many centralized lighting automation systems use this
type of control. To control your PowerLED using a PWM signal, the wiring
and signal parameters should be configured according to details below.
Note:
5.0mS<T
PWM
<8.33mS (PWM Frequency=120-200Hz)
Dim signal voltage to be 0VDC<V
O
<1.7VDC &
2.1VDC<V
I
<30VDC
Current Sink I=1mA
Imtra
PowerLED
Voltage Supply
(battery, converter, etc)
Control System
PWM Control
Module
Imtra
PowerLED
PWM Signal Parameters
V
T
V
I
0
V
O
T
PWM
(+)
(-)
To other PowerLEDs
