ENVIROTECH ALARMS - IMRITA - INSTALLATION INSTRUCTIONS - VERSION 1.0
The imrita complete water leak detector combines both flow and sensor based technology to help
prevent the escape of water in the event of a leak. Installing the main unit on the mains incoming water
pipe will allow the flow of water into the property to be monitored continuously. This flow can be
compared to threshold levels set for the property and will automatically switch off the water should they
be exceeded. At the same time, the wireless sensor probes can be positioned in the most vulnerable
areas, such as kitchens and bathrooms. As soon as water comes into contact with one of them, the
water will be switched off.
Introduction
The main alarm unit houses the valve, flow meters and electronics for setting up the system. It is housed
in a waterproof case to protect the electronics and offer a long service life. All the settings are made
either via the main alarm unit or by using the E-Water app.
Main Alarm Unit
Menu Button
Press and hold for 5
seconds to enter the
settings mode.
Open Button
This will open the
valve if closed.
It is also used for
incrementing the
values during setting
Close Button
This will close the
valve if open.
It is also used to
toggle the values
during setting
Product Specification
Part Number:
Connection Size:
Minimum Detectable Flow:
Inlet Pressure:
Water Flow Rate:
Voltage Rating / Frequency:
Power:
Application:
Water temperature range:
Dimensions (Main Unit):
Remote Probes:
IMT-P-ZL6
3/4"
1-2 l/h
1 - 4 bar
4.0m³/h
100 - 240VAC ~ 50/60Hz
2W
Potable Water
5ºC ~ 38ºC
(L)183.5 x (W)85 x (H)96.5mm
30m range ~ maximum of 7
