S t e p 7
Ro u t e T h e We i g h t C a b l e
1)Put the clip tied on the weight pin leash onto the Top
Plate(#35) as shown below,next connect the Weight
Cable (#39) to the Top Plate (#35).
2)Route the Weight Cable (#39) up and over the two Pul-
leies A (#21), next, secure them to the Main Upright
(#1) using:
3)Route the Weight Cable (#39) down and under the Pul-
ley B (#21) next, secure them to the Main Upright (#1)
using:
4)Route the Weight Cable (#39) under the Pulley C(#21) ,
then secure them to the Side Upright (#2) using:
5)Route the Weight Cable (#39) over the Pulley D (#21),
then secure them to the Side Upright (#2) using:
6)Route the Weight Cable(#39) under the Pulley E(#21) ,
then secure them to the Back Rocker (#4) using:
7)Route the Weight Cable(#39) under the Pulley F(#21) ,
then secure them to the Side Upright(#2) using:
8)Route the Weight Cable(#39) under the Pulley G(#21) ,
then secure them to the Back Rocker (#4) using:
9)Route the Weight Cable(#39) under the Pulley H(#21) ,
then secure them to the Side Upright (#2) using:
10)Connect the looped end of the Weight Cable (#39) to
the Gimbal (#78), then secure the Gimbal (#78) to the
Back Rocker (#4) using:
11)Adjust the Weight Cable (#39) using the Jam Nut as
shown below.
12)Make sure that the cable is in the grooves of all pull-
eies, then fully tighten all bolts and nuts .
13)Select an approprate weight with the Weight Pin.
Φ
Φ
Φ
Φ
Φ
Φ
two Allen Bolts (#55) M10×45
four Washers (#65)
11× 20×2
two Nylon Locknuts (#66) M10
one Shoulder Bolt (#62) M10×50
one Nylon Locknut (#66) M10
two Pulley Covers (#34)
one Shoulder Bolt (#62) M10×50
one Pulley Covers (#34)
one Nylon Locknut (#66) M10
one Washers (#65)
one Allen Bolts (#57) M10×95
two Dividing Bushings (#45)
one Nylon Locknut (#66) M10
one Shoulder Bolt (#62) M10×50
two Pulley Covers (#34)
one Nylon Locknut (#66) M10
one Shoulder Bolt (#62) M10×50
two Pulley Covers (#34)
one Nylon Locknut (#66) M10
one Shoulder Bolt (#62) M10×50
two Pulley Covers (#34)
one Nylon Locknut (#66) M10
one Shoulder Bolt (#62) M10×50
two Pulley Covers (#34)
one Nylon Locknut (#66) M10
one Allen Bolt (#54) M12×40
two Washers (#79)
13× 24×1.5
one Nylon Locknut (#80) M12
11× 20×2
12
