Clip
Top plate
Jam Nut
13
S t e p 8
Ro u t e T h e C a b l e
1)Put the clip tied on the weight pin leash onto the Top
Plate(#41) as shown, next connect the Cable(#44) to
the Top Plate(#41).
2)Route the Cable(#44) up and over the two Pulleies A
(#23).then secure them to the Main Upright(#1) using
3)Route the Cable(#44) down and under the Pulley B
(#23),then secure them to the Main Upright(#1) using
4)Connect the looped end of the Cable(#44) to the Cam
(#7), secure it using one Screw(#89) as shown below.
5)Adjust the tension of the Cable (#44) using the Jam
Nut as shown below.
6)Make sure that the cable is in grooves of all pulleies
then fully tighten all bolts and nuts .
7)Select an approprate weight with the weight pin.
two Allen Bolts(#51) M10×45
four Washers(#60)
11× 20×1.5
two Nylon Locknuts(#62) M10
one Shoulder Bolts(#55) M10×50
two Half-pulley Covers(#71)
one Nylon Locknuts(#62) M10
Φ
Φ
1
2