Improvements 433992 Owner'S Manual Download Page 2

LED Area

Lights in Rim

OPERATION INSTRUCTIONS

SPOTLIGHT

The  spotlight  is  equipped  with  a  high  power  and  regular  power  beam  that  can  be 
selected by the “MAIN BEAM” switch on the side of the spotlight. The regular beam 
draws  less  power  from  the  battery  and  will  operate  for  longer  periods  (up  to 
approximately 69 minutes) before recharging is necessary. The high power beam will 
provided a longer range beam with more intensity when required but will have shorter 
operating times (up to approximately 35 minutes). Place switch in “LOW” postion for 
regular beam and “HIGH” position for high beam.  
Spotlight  is  equipped  with  an  auto  shut  off  to  protect  battery  from  over  discharge. 
When light goes out, place switches in off (middle) position and recharge unit as soon 
as possible.  
Spotlight can also be operated directly from 12 volt vehicle outlet socket using the DC 
adaptor cord equipped with the 12 volt plugs . Plug cord in the DC 12V power outlet 
socket on the side of the light and the other end into the vehicle. Spotlight can now be 
operated without battery power being consumed. Spotlight cannot be operated with 
AC charging adaptor. AC Adaptor is for charging battery only.

      

 

WARNING!

The spotlight becomes very hot during use.  DO NOT touch lens or block lens area 
during operation.  DO NOT place the unit on surfaces that may be damaged from heat.  
Allow the unit to cool before storing.
Light is very powerful.  DO NOT shine into the eyes of humans or animals.
Keep out of reach of children.

 

      

 

CAUTION!

Unit is not waterproof.  DO NOT use spotlight under water or immerse in water.

LED AREA LIGHT

The Spotlight is equipped with bright LED lights embedded in the 
rim.  These  will  provide  an  area  light  for  working  and  general 
illumination. To operate, place LED/USB switch on side of unit in 
LED position. Area light will operate continuously for many hours 
on a full charge.

ADUSTABLE HEAD

To adjust head angle, gently pull up on rim at bottom. Angle can 
be adjusted to 4 different positions indicated by a “ click “ sound. 
Do not force head beyond final point. Return head to closed position for storage to 
prevent damage to mechanism.

USING AS A 12 VOLT DC POWER SUPPLY

The spotlight is equipped with an outlet socket and can be used to operate most 12 volt 
auto accessories and appliances (10 AMP maximum) equipped with a cigarette lighter 
plug.  Simply lift up cover on socket and plug in appliance.  NOTE ; socket is live so 
appliance will be instantaneously powered.  Length of time appliance will operate will 
depend  on  condition  of  battery  and  current  draw  of  appliance.    Do  not  fully  drain 
battery. Discontinue use immediately when battery power starts to weaken.  Recharge 
unit as soon as possible and before further use.
Power outlet is protected by an internal circuit breaker to prevent damage to unit in 
case appliance has a short circuit or exceeds 10AMPS.  If circuit breaker is tripped, 
disconnect appliance and have it checked.  Circuit breaker will automatically reset once 
it cools down (approx. 5-10 minutes).  DO NOT PLUG  A CIGARETTE LIGHTER INTO 
THE OUTLET OF THE SPOTLIGHT.

USB Power Port

On/Off switch

for LED/USB

Rubberized Hand Grip

Shoulder Carry 

Strap Included

Charging

The spotlight has a maintenance free, built in sealed lead acid battery. Although the 
unit arrives partially charged from the factory, it MUST BE FULLY CHARGED BEFORE 
FIRST USE. This inital charge pre-conditions the battery.  Failure to follow this 
procedure may permanently damage the battery.

Spotlight is supplied with an AC adaptor for charging from household wall socket (110 
volt) and a DC adaptor for charging from 12 volt vehicle lighter socket. Make sure all 
switches are in the off ( middle ) position.

For charging with AC household charger, locate jack on side of spotlight and plug in 
cord. Plug into appropriate power source.  The red LED indicator light above the 
jack will illuminate indicating that the spotlight is charging. If the indicator light fails to 
illuminate, check power source to make sure it is live. 

Red charging light will go out when battery has reached full charge and begin to flash 
slowly ( appx. every 5 – 60 seconds depending on charge time )

NOTE : Adaptor will become warm during charging operation

For charging from vehicle, use the DC adaptor cord with the auto plugs on both ends. 
Plug one end into the 12 volt power outlet socket located on the opposite side of the 
spotlight and the other end into the cigarette lighter socket of your vehicle. Vehicle 
should be running for full charging to take place. NEVER leave vehicle running in an 
enclosed or poorly ventilated space.

NOTE: The red LED charging indicator light does not illuminate for DC charging.

The spotlight should be fully charged before initial use to pre-condition the battery. 
Failure to do so will result in shortened battery operational capacity and reduced life 
cycle.

Subsequent recharging will take approximately 10 to 14 hours with AC adaptor and 
4-6 hours with DC adaptor cord to reach full charge from  discharged state. NOTE: 
Some vehicles’ cigarette lighters and 12 volt power ports do not operate unless the 
ignition switch is in the accessory position.

Unplug charger after the spotlight is fully charged. The unit is now ready to use.
However, we recommend recharging your spotlight every 2 months if not in use.

        NOTE

Spotlight is equipped with an auto shut off to protect battery from over discharge. 
When light goes out, place switches in off ( middle ) position and recharge unit as 
soon as possible.  DO NOT leave the spotlight in total discharged state for an 
extended period of time. Keep battery power fully charged. Unlike some rechargeable 
batteries, frequent charging will not harm and will in fact improve the performance of 
the internal battery.

Spotlight cannot be operated with AC charging adaptor plugged in.. AC Adaptor is 
for charging battery only.

       CAUTION!

•  DO NOT recharge the spotlight with any other adaptors than those supplied 
 

with the unit. 

THIS SPOTLIGHT MUST BE FULLY CHARGED BEFORE  FIRST USE. FAILURE TO DO

SO MAY PERMANTLY DAMAGE BATTERY. (See section on charging)

Heavy Duty

Rubberized Lens 

Protector

Hi/Lo Powerful H4

12V 120W/60W

Large 10 in 

reflector

Rubberized Housing

12 Volt DC

Power Outlet Socket

On/Off switch for 

High/Low beam

Red charging

light indicates

unit is charging
Will begin to flash slowly 

when battery reaches 

full charge
AC charging jack

AC household charger

for recharging only

Spotlight cannot be operated 

with AC charging adaptor

DC car adaptor for 12 volt

operation or 12 volt charging

functions.

BE SURE TO READ AND SAVE THESE SAFETY
INSTRUCTIONS BEFORE USING THIS UNIT

IMPORTANT SAFETY INFORMATION

Please read this manual thoroughly before operating your new product, as
it contains the information you need to become familiar with its features 
(shown below) 

Please keep this manual on file for future reference. 

Reviews: