Impossible I-1 User Manual Download Page 17

Page: 17 / 25

24 | English

SAFETY INFORMATION

CAUTION – RISK OF ELECTRIC SHOCK – DO NOT

OPEN/DISASSEMBLE THE MOTORIZED ROLLER

SYSTEM.

· Do not disassemble the device. Incorrect reassembly

can cause electrical shock if the device is used again.

· Do not immerse the device in water or other ﬂ uids.

· Do not operate the device in a high humidity environ-

ment or very dusty environments.

· Do not attempt to tamper with, adjust or remove the

battery and/or the electronics located below the rollers

behind the device’s ﬁ lm door.

· Do not attempt to remove the door itself as it is

connected electronically to the body of the device.

Doing so is unsafe, will likely damage your device, and

will void your warranty.

· Do not insert metal objects into the product.

· Do not insert any objects into the rollers or gears.

· Keep small children and infants away from the

device to avoid them being injured by the device’s

moving parts.

· Do not use or store the product near any heat source

or any type of equipment that generates heat, includ-

ing stereo ampliﬁ ers.

· Do not use the device near ﬂ ammable or explosive

gases.

· Do not charge the device if you notice any unusual

odors, noise or smoke.

· Do not attempt to disassemble the ﬁ lm’s battery or

modify it in any way (if using 600-type ﬁ lm). If battery

ﬂ uid gets into your eyes, immediately rinse your

eyes with fresh cold running water and seek medical

attention immediately.

BATTERY AND CHARGER

· This device uses a custom Impossible lithium ion

battery that is non-removable and mounted inside the

camera body. No other type of battery can be used.

Battery replacement can only be done by Impossible

Service Centers. The battery will provide many years of

service if properly used.

· Power consumption varies depending on the

environment the device is used in and how the device

has been stored. Used directly after full charge, the

battery will power the processing of up to 15 ﬁ lm

packs with ﬂ ash exposures, or three days of use on

and off. Due to the high energy requirements of the

ﬂ ash, we recommend charging the camera before

every session for best results.

· Once the battery energy level falls below a certain

level, the device will no longer process ﬁ lm. The LED

will blink and signal when it needs to be recharged.

This is to avoid a photo getting stuck as it’s being

processed through the roller system.

· The rechargeable battery is not fully charged at the

time of purchase. Charge the battery fully with the Im-

possible USB charging cable (provided). This usually

takes 1-2 hours (can vary depending on usage).

· The supplied USB charging cable has been tested and

certiﬁ ed to work with the Apple iPhone power adaptor.

While it can be used in other USB ports, e.g. comput-

ers, USB power adaptors, TVs, cars etc., Impossible

cannot guarantee correct operation.

· When the device is no longer in use, please recycle

it properly.

USAGE ENVIRONMENT

· The I-1 must be powered by direct current only.

· Charge the I-1 using the USB charging cable

provided in the camera box.

· To protect the high-precision technology contained in

this device, never leave the camera in the following

environments for an extended period of time: high

temperature (+40°C/104°F), high humidity, places

with extreme changes in temperature (hot and cold),

direct sunlight, sandy or dusty environments such

as beaches, damp places, or places with strong

vibrations.

· Do not drop the device or subject it to severe shocks

or vibrations.

· Do not push, pull or press on the lens.

English | 25

COMPLIANCE

Important directions for using Lithium-Ion-Batteries

1. Do not throw into ﬁ re.

2. Do not short circuit.

3. Do not disassemble.

4. Do not continue to use when damaged.

5. Dispose correctly.

EU DECLARATION OF CONFORMITY

Hereby, Impossible B.V. declares that the Impossible

I-1 Analog Instant Camera is in compliance with the

appropriate essential requirements of Article 3 of the

R&TTE and other relevant provisions, when used for

its intended purpose.

FCC

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions:

(1) this device may not cause harmful interference,

and (2) this device must accept any interference

received, including interference that may cause

undesired operation.

Caution: The user is cautioned that changes or

modiﬁ cations not expressly approved by the party

responsible for compliance could void the user’s

authority to operate the equipment.

Note: This equipment has been tested and found to

comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against

harmful interference in a residential installation. This

equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there

is no guarantee that interference will not occur in a

particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

· Reorient or relocate the receiving antenna.

· Increase the separation between the equipment

and receiver.

· Connect the equipment into an outlet on a

circuit different from that to which the receiver is

connected.

· Consult the dealer or an experienced radio/TV

technician for help.

This equipment complies with FCC radiation exposure

limits set forth for an uncontrolled environment. End

user must follow the speciﬁ c operating instructions

for satisfying RF exposure compliance. This transmit-

ter must not be co-located or operating in conjunction

with any other antenna or transmitter.

INDUSTRY CANADA (IC)

This device complies with part 15 of the FCC Rules

and Industry Canada license-exempt RSS standard(s).

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference,

and (2) this device must accept any interference

received, including interference that may cause

undesired operation.

Le présent appareil est conforme aux CNR d'Industrie

Canada applicables aux appareils radio exempts de

licence. L'exploitation est autorisée aux deux condi-

tions suivantes : (1) l'appareil ne doit pas produire

de brouillage, et (2) l'utilisateur de l'appareil doit

accepter tout brouillage radioélectrique subi, même

si le brouillage est susceptible d'en compromettre

le fonctionnement.

SOUTH KOREA

ጄఙඳ໓໕๗௴ဪဧთ႖ኒጯཅਜ਼௻ໜၦၰၗ

TAIWAN

本產品符合低功率電波輻射性電機管理辦法第十二條、
第十四條等條文規定
1. 經型式認證合格之低功率射頻電機，非經許可，公
司、商號或使用者均不得擅自變更頻率、加大功率或變
更原設計之特性及功能。
2. 低功率射頻電機之使用不得影響飛航安全及干擾合法
通信；經發現有干擾現象時，應立即停用，並改善至無
干擾時方得繼續使用。
前項合法通信，指依電信法規定作業之無線電通信。
低功率射頻電機須忍受合法通信或工業、科學及醫療用
電波輻射性電機設備之干擾。